Touchpad - HP EliteBook x360 1040 G5 Maintenance And Service Manual

TouchPad

NOTE: The TouchPad spare part kit does not include the TouchPad cable. The TouchPad cable is included in
the Cable Kit, spare part number L41024-001-001.
NOTE: The TouchPad spare part includes rubber padding.
Description
Equipped with NFC module antenna (includes adhesive)
Not equipped with NFC module antenna
Before removing the TouchPad, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
Remove the TouchPad:
1. Release the ZIF connector (1) to which the TouchPad cable is connected, and then disconnect
the TouchPad cable from the system board.
2. Detach the TouchPad cable (2) from the keyboard/top cover. (The TouchPad cable is attached to
the keyboard/top cover with adhesive.)
3. Release the ZIF connector (3) to which the NFC module antenna cable is connected, and then disconnect
the NFC module antenna cable from the NFC module.
4. Detach the NFC module antenna cable (4) from the keyboard/top cover. (The NFC module antenna cable is
attached to the keyboard/top cover with adhesive.)
5. Remove the six Phillips M2.0×2.4 screws (5) that secure the TouchPad to the keyboard/top cover.
Bottom cover on page
Battery on page 28).
27).
Component replacement procedures
Spare part number
L41020-001
L42312-001
39