Seastar Solutions HC5370-3 Installation Instructions Manual page 11

WARNING
System Connection
WARNING
Side Mount & Splashwell Mount Cylinders
SeaStar Solutions recommends that the hose and hose fittings are
checked on a regular basis to ensure the safe operation of the
steering system.
SECURE WITH
WRENCH HERE
WHILE TIGHTENING
LOCKNUT (ITEM 1)
2
Figure 4.
Figure 5.
1. Refer to figure 6 on page 8 for hose/tube to fitting connection.
2. If not already completed, install fittings into helm as per specific
instructions suppled with your helm pump.
There is NO requirement for pipe sealant of any kind when using
an ORB fittings. A "LIQUID" Teflon based pipe sealant IS required
when using NPT type fittings. DO NOT use Teflon Tape or any
other tape type sealers.
3. Helm Pump Connection
a) SeaStar Outboard Hose - While holding the fitting body securely
with a wrench, torque the hose end nut to 15 ft-lbs.
HYDRAULIC STEERING
HOSE AND TUBING
SECURE WITH
WRENCH HERE
WHILE TIGHTENING
LOCKNUT (ITEM 1)
1
2
THREAD FITTING BY HAND UNTIL
WASHER CONTACTS THIS FACE
1
7