Assembling And Disassembling The Wheels (4-Wheel Version And Rear Wheels On The 3-Wheel Version) - Invacare Colibri Service Manual

®
Invacare - Colibri
6.5.3 Assembling and disassembling the wheels (4-wheel version and rear wheels
on the 3-wheel version)
ATTENTION! Risk of accident.
When parking the scooter on the scooters support wheels it is no longer slowed by the
engine brake. The scooter can roll away out of control.
· Place the scooter rear frame on a supporting wooden block before you remove the wheels.
ATTENTION! Risk of accident.
Accidental rolling can lead to accidents.
· Secure the scooter against rolling away.
NOTE:
When disassembling, note the position of small parts such as screws and washers. Put small
parts down so that they can be reassembled in the right sequence.
Requirements:
· Open spanner 12 mm
· Rubber hammer
· Flat screwdriver
· Self-locking nut 12 mm
· Block of wood
· Secure the scooter against rolling away.
· Position the block of wood under the frame in
the vicinity the battery box.
Removing the wheel:
· Remove the protection cap (1) with a flat
screwdriver.
· Use the 12 mm open spanner to loosen the lock
nut.
· Remove the wheel.
· If necessary, loosen the wheel by tapping it lightly
with a rubber hammer.
Assembling the wheel:
· Assembly of the wheel is carried out in the
reverse order.
· Use a new self-locking nut.
· Test all functions (test drive).
SERVICE MANUAL
35