Handset Registration; Easy Registration; Network Settings - Yealink W53P Quick Start Manual

Handset Registration

You can register up to 8 handsets to one W60B base station. Each handset can
be registered to 4 different base stations.
When the handset LCD screen prompts "Unregistered!", long press
base station till the registration LED flashes.
There are two methods to register a new handset:

Easy Registration:

1. Press the Reg soft key on the handset to register quickly.
Normal Registration:
1. Press the OK soft key on the handset, and then select Register Handset.
2. Select the desired base station and then press the OK soft key. The handset
begins searching the base station.
3. Press the OK soft key after searching a base station successfully.
4. Enter the base station PIN (default: 0000), and then press the Done soft key to
complete registration.
To register to multiple base stations, press OK to enter the main menu, and se-
lect Settings->Registration->Register Handset, then repeat steps 2-4.
Note:
• If the handset is registered to the base station successfully, the handset LCD
scree prompts "Handset Subscribed" and "Base NO."( the last 4 characters
indicate the base station's MAC address).
• If the handset LCD screen prompts "Searching for Base", check that your base
station is powered on.

Network Settings

You can configure the base station to obtain network settings in one of the fol-
lowing ways:
DHCP
By default, the base station attempts to contact a DHCP server in your network to
obtain the valid network settings, such as IP address, subnet mask, gateway ad-
dress and DNS address.
Static
If the base station cannot contact a DHCP server for any reason, you need to
configure the IP address, subnet mask, gateway address, primary DNS address
and secondary DNS address for the base station manually.
on the
5