Page 1
2/28/2019 Provisioning a Yealink DECT W52P/W56P with the 3CX v15 How to configure Yealink W52P/H, W56P/H, W60P/B for 3CX This guide applies to v15 SP4 and higher. On this topic How to configure Yealink W52P/H, W56P/H, W60P/B for 3CX Supported Models: Yealink DECT series and Handsets...
Page 2
How to Factory Reset Yealink WP Series document. Step 3: Provisioning a Yealink WP station Yealink WP-series can only be provisioned using the manual provisioning method. The general howto for a local LAN setup is outlined here: Yealink WP Series Manual Provisioning.
Page 3
2/28/2019 Provisioning a Yealink DECT W52P/W56P with the 3CX v15 2. Enter the “Local SIP Port” and “RTP Audio Ports” the remote device should be configured to. This allows to build an inbound NAT on the remote firewall. Note: Ensure that the firewall has the given ports forwarded to the internal IP of the base station. Also check that SIP ALG is disabled in the firewall.
Page 4
2/28/2019 Provisioning a Yealink DECT W52P/W56P with the 3CX v15 1. Set the “Provisioning Method” to “3CX SBC (remote)” 2. Enter the local IP address of 3CX Session Border Controller in the remote network and the SIP Port used by the SBC (default:5060) Note: The 3CX SBC must be installed on a computer in the remote location.
Need help?
Do you have a question about the W52P and is the answer not in the manual?
Questions and answers