Signalling Method To Control The Isdn Services - Siemens A30853 Operating Instructions Manual

27.11.98

Signalling method to control the ISDN services

kap01.fm5
Programming the telephone settings
In most of the countries local network operators use the
socalled "functional protocol" to control the following
ISDN services:
1
2
3
4
The default settings of your Profiset 30isdn is preset to
the functional protocol. If the above-mentioned ISDN
services work correctly (
should keep on controlling these services via functional
protocol.
In some countries, however, keypad signalling is used to
control the above ISDN services instead of the functional
protocol. You will recognize that when it is possible to
control the ISDN services by entering keypad sequences
(e.g. *21#, *#21# a.s.o.).
To find out which ISDN services are controlled by keypad
signalling in your country, contact your local network op-
erator.
a
Handset is on-hook.
S08
Start the programming procedure.
T
Enter the password if necessary.
1 ... 4
Enter the code (1 ... 4) for the ISDN service.
0 or 1
Enter the code (0 or 1) for the signalling method.
S
Save the settings.
Note:
if you change the national variant (
the signalling method for all ISDN services is set
to functional protocol.
Profiset 30isdn engl.: A30853-X300-B107-1-7619
Call Forwarding Unconditional (CFU)
Advice of Charge (AOC)
Hold, Consultation/Toggling (HOLD)
Three-party conference (3PTY)
page 12, 22, 23, 34), you
page 32),
33