Ending A Conference - Siemens A30853 Operating Instructions Manual

27.11.98
Calls involving two or more parties

Ending a conference

Ending a conference by disconnecting a party
h and 0 or 1
Ending a conference and toggling between parties
Exiting from a conference
24
kap01.fm5
You can disconnect one party or toggle between the two
parties. To terminate the conference completely, replace
the handset.
d
A conference is in progress.
Press the Disconnect key and then "0" or "1" .
Enter "0" if you want to disconnect the party whose call
number is not shown on the display.
Enter "1" if you want to disconnect the party whose call
number is shown on the display.
d
A conference is in progress.
g
Press the Conference key.
The conference is ended. The symbol K disappears on
the display.
You are back in the consultation call before the confer-
ence has been set up. You are connected to the first
party and the second party is put on hold.
You can now toggle between the two parties via the
Consultation key (
During a conference, the call number of the
party added-on last is shown on the display, if is
known.
Call numbers are not displayed, for example,
in the case of incoming calls with number sup-
pression or calls from analog stations.
d
A conference is in progress.
b
Replace the handset.
Both parties are disconnected.
The conference is terminated.
Profiset 30isdn engl.: A30853-X300-B107-1-7619
page 22).