Advertisement
Utility Manual
CPD8500 EMM calibration sled
EN
Transducer utility manual 0020646001
© 10/2018, Mensor, LP. All rights reserved.
Mensor is a registered trademark of Mensor, LP.
All other brand and product names are trademarks or registered trademarks of their respective companies.
Prior to starting any work, read the operating instructions!
Keep for later use!
Advertisement
Table of Contents
Related Manuals for WIKA CPD8500
Summary of Contents for WIKA CPD8500
- Page 1 Utility Manual CPD8500 EMM calibration sled Transducer utility manual 0020646001 © 10/2018, Mensor, LP. All rights reserved. Mensor is a registered trademark of Mensor, LP. All other brand and product names are trademarks or registered trademarks of their respective companies.
-
Page 2: Table Of Contents
Additional features ....... . . 8 WIKA operating instructions EMM Calibration Sled... -
Page 3: Introduction
1. Introduction Equipment required EMM Calibration Sled - P/N 0019780001 ■ EMM - P/N 0019582001 ■ CPD8500 EMM Cal Sled application software - P/N 0020646001 ■ Pressure Standard capable of 1.1 bar abs pressure ■ Temperature standard 0 to 50°C ■... -
Page 4: Calibration Procedures
The Com Test button brings up the window below. If the EMM is not connected or a problem exists an error will be shown. Figure 2.2 A – Successful com test Figure 2.2 B - Communication error WIKA operating instructions EMM Calibration Sled... - Page 5 EMM’s case. The tubing can then be applied over the sensor barb. The other end of the tubing can be connected to a pressure source with the adaptor fitting. The adaptor fitting has a 7/16-20 male thread Head temperature linearity Selection of the linearity button brings up the following screen. WIKA operating instructions EMM Calibration Sled...
- Page 6 Figure 2.5 –Linearity correction graph Other options are available such as reducing the number of calibration points and upscale-downscale calibrations. By changing the Number of points and selecting Update Grid fewer test points can be used. WIKA operating instructions EMM Calibration Sled...
-
Page 7: Use Of Multiple Calibration Methods
“Apply” value shown. The 2-pt Cal windows are shown below. Figure 2.7 A - Displays for both temperatures sensors Figure 2.7 B - Displays for both barometric pressure sensors Figure 2.7 C - Displays for both relative humidity sensors WIKA operating instructions EMM Calibration Sled... -
Page 8: Additional Features
Mensor Corporation WIKA Alexander Wiegand SE & Co. KG 201 Barnes Drive Alexander-Wiegand-Straße 30 San Marcos, TX 78666 • USA 63911 Klingenberg • Germany Tel. (+1) 512 3964200-15 Tel. +49 9372 132-0 Fax (+1) 512 3961820 Fax +49 9372 132-406 E-Mail sales@mensor.com...
Need help?
Do you have a question about the CPD8500 and is the answer not in the manual?
Questions and answers