Installing Duo Driver - ABB COM600 Station Automation Series User Manual

1MRS756125
4.8.
COM600 Station Automation Series
User's Guide
The other properties are set according to user preference, but can left as default. These
are:
• Command Write Value
The value that will be written to the command OPC item. Default value is 1.
• Command Write Interval
How often the command sent. Default value is 5 seconds.

Installing Duo Driver

Duo Driver is available when the optional LAN card is installed in the COM600.
Before installation it is recommend to rename Intel(R) PRO/1000 MT Dual Port Server
Adapter ports to DUO Line A and DUO Line B. Open the Network Connections dialog
and select the Properties for the Duo Driver devices. Configure static IP address on
DUO Line A and disable the TCP/IP stack on DUO Line B.
To install the Duo Driver:
1. Run the Duo Driver Setup Wizard file,
C:\DuoDriver\Install_DuoDriver.msi
2. Click Next.
3. At the Select Installation Folder dialog, select Everyone
Click Next.
4. On completion of the installation, a notice stating that the software has not passed
Windows Logo testing will be displayed. This is normal.
Click Continue Anyway.
5. During the installation process, the file virtualnic.sys will be required. You will need
to browse to the location C:\Program Files\DuoDriver.
Click OK.
6. When the installation is complete, the following message is displayed:
Driver not yet ready! All parameters will be ignored until initial Pairing is done.
Click OK.
After installation, the Duo Driver Management and Supervision Interface will open.
Configure the following:
1. Set Line A/Primary to Duo Line A and Line B/Secondary to Duo Line B
Click Apply.
The MAC address for each line will be shown.
2. Enter a valid MAC address for MAC Address A or leave as default.
Click Apply.
3. For MAC Address B, enter the same value as used for MAC Address A.
Click Apply.
4. To complete the configuration, click OK.
COM600 3.2
(in COM600 computer)
49