Table of Contents
Advertisement
5.1.6 Installing the USB driver
When the NextMove e100 is powered, Windows will automatically detect the controller and
request the driver.
1. Windows will prompt for the driver. On Windows XP, click Next on the following dialogs
and Windows will locate and install the driver. For Windows Vista and newer, no
interaction should be necessary.
2. When installation is complete, a new Motion Control category will be listed in Windows
Device Manager.
The NextMove e100 is now ready to be configured using Mint WorkBench.
Note: If the NextMove e100 is later connected to a different USB port on the host
computer, Windows may report that it has found new hardware. Either install the
driver files again for the new USB port, or connect the NextMove e100 to the
original USB port where it will be recognized in the usual way.
MN1941WEN
Operation 5-3
Advertisement
Table of Contents
