CipherLab 2200 User Manual page 19

錯誤! 使用 [常用] 索引標籤將 Heading 1 套用到您想要在此處顯示的文字。
The example below shows how to set string parameters:
Steps Action
1 Power on the scanner...
2 Enter the Configuration Mode...
3 Read a Setup barcode...
For example,
Special setup
barcodes
Hexadecimal
barcodes
4 Exit the Configuration Mode...
5 The scanner will automatically restart itself...
OR
Scanner Feedback if Successful
The scanner will respond with a long beep
(high tone) and its LED indicator will
become solid red and go off quickly.
The scanner will respond with six beeps
(high-low tone repeats three times), and
its LED indicator will become flashing red.
The scanner will respond with one short
beep if reading a special setup barcode
such as "Prefix Code", indicating the setup
requires reading more barcodes.
When "Keyboard Wedge" or "USB HID" is
configured for interface, Key Type and Key
Status will then become applicable. Decide
whether or not to change key status when
"Normal Key" is selected for Key Type.

Refer to Appendix III
Read the "Hexadecimal Value" barcodes
for the desired character
example, read "2" and "B" for the scanner
to prefix the character "+".

Refer to Appendix IV "Hexadecimal
System"
The scanner will respond with two beeps
(low-high tone) when the input values are
validated.
Same as for Enter the Configuration Mode.
Same as for Power on the scanner.
Update
string. For
11