Table of Contents
Advertisement
Wireless Alarm Bar Installation Guide
3.1.2. Optional Pole Mounting
If it is not mounted on a wall or other flat surface, the Wireless Alarm Bar can be attached to a pole
using optional brackets (Part Number 019-2052-000).
Note: The pole must be between 1" (25mm) and 2.5" (63mm) in diameter.
Slip the screws through the two holes that are side by side in order to mount the Wireless Alarm
Bar's plate to a vertical pole.
Loosely assemble the clamp parts around the pole. Note that the screws have nuts that fit into the
clamp parts. The clamp parts are designed to hold the nut so that you do not need to use a wrench
on this side. Hand-tighten the parts until snug.
Use a hex wrench to tighten the hex screws from the front of the enclosure:
Once the clamp parts and the enclosure are securely held against the pole, stop tightening.
9
Advertisement
Table of Contents
