Table of Contents
Advertisement
Wireless Alarm Bar Installation Guide
3.2.4. Reassembly
Once wiring is completed, carefully place the cover back onto the base, avoiding damage to the
mating surfaces. Make sure it is perfectly aligned with the base and then slowly tighten the four
screws.
3.2.5. External Grounding
If external or redundant grounding (earth connection) is required, a threaded post is located on
plate for wiring to ground (earth). Place the round lug from the ground wire over the threaded post
and then the split washer, flat washer, and nut. Tighten the nut and then connect the other end of
the ground wire to an appropriate grounding location.
Ground
wire
IMPORTANT!
Prior to factory shipment, the Wireless Alarm Bar is tested. However, the instrument should be
tested after installation.
Threaded
post with nut
and washers
14
Advertisement
Table of Contents
