Status Indication - Baofeng DM-1701 User Manual

■ Accessories installation
1. Install / remove the antenna
Turn off the radio and insert the antenna into the mounting hole and turn clockwise. (Figure 1-1)
When removing the antenna, turn it counterclockwise to remove the antenna. (Figure 1-2)
Do not shake the top of the antenna by hand, otherwise it will reduce the working performance and service
life of the antenna.
2. Install / remove the battery
●Install the battery
Align the battery with the battery holder on the back of the walkie-talkie. Push the battery firmly into the
walkie-talkie and slide the battery up until it locks into place. (Figure 2-1)
●Remove the battery
To remove the battery, turn off the transceiver. Slide the battery latch into the unlocked position and hold,
and then slide the battery downward and out of the battery mount.(Figure 2-2)
3. Install / remove the belt clip
●Unscrew the two screws on the battery. Align the two screw holes in the belt clip with the screw holes in the
top of the battery, and then tighten the screws (Figure 3)
●Loosen and remove the screw from the belt clip (it is recommended that you screw the screw to the battery for
the next time you are installing and using the belt clip).
4. Install external headphones / microphone (optional separately)
Open the headset cover, the headset plug into the headset hole will be ok. When you do not need to use the
headset, unplug the headset plug from the earphone jack and cover the earphone cap. When not using the
universal interface, please cover the dust cover. (Figure 4)

■ Status indication

★Description of LCD Icons
Icon name Icon
Signal strength
icon
Transmission
M
power icon
Speaker icon
Relay mode icon
Scan icon
Battery power
icon
Pointer icon
Description of product status
The more signal bars, the stronger the signal is
The current channel transmits at high power
The current channel transmits at middle power
The current channel transmits at low power
Speaker is enabled, and reception is effective
The current transmission frequency is the reception frequency plus a frequency bias
(positive bias)
The current transmission frequency is the reception frequency minus a frequency bias
(negative bias)
Currently in offline state
The scan is on and is in normal mode
The more bars, the more battery power
Currently pointing to the main digital mode; press A/B button to switch the main channel
up and down. When double-waiting is turned on and works in digital sub-channel, the
icon is