Remote Monitoring - Baofeng DM-1701 User Manual

contact list) and stays in the display interface. Press [EXIT] to exit.
■Radio detection
In digital mode, you can initiate radio detection to a contact without interfering with each other to confirm
whether the other party has turned on the unit or uses in the current channel.

Initiate radio detection:
Select single call contact (enter "Menu -> Contacts -> Press []/[] to select single call contact ->Radio
detection"), or press the * button in the main interface to enter single call number, select "Radio detection", and
press the [MENU] button to start; "Radio detection is successful" displays if it is successful, and "Radio detection
failed" displays if fails. When the radio detection is successful, you can press PTT to call the other party.

Receive radio detection:
Reply automatically after receiving radio detection command.

■Remote monitoring

In digital mode, you can remotely activate the microphone of a contact, and monitor the voice and background
sound of the other party.

Initiate remote monitor:
Select single call contact (enter "Menu -> Contacts -> Press []/[] to select single call contact ->Remote
monitor"), or press the * button in the main interface to enter single call number, select "Remote monitor", and
press the [MENU] button to start; "Remote monitor is successful" displays if it is successful, and "Remote monitor
failed" displays if fails. When the radio detection is successful, you can monitor the background sound and voice
of the other party.

Receive remote monitor:
After receiving the remote monitor command, it automatically starts transmitting voice and surrounding
environment background sound, and exits automatically when the transmission time is up.
Note: This function works only if the function is set and turned on by writing-frequency software.
■Radio activation
In digital mode, you can send an activation command to a contact to resume normal use of the two-way radio.

Initiate radio activation:
Select single call contact (enter "Menu -> Contacts -> Press []/[] to select single call contact ->Radio
activation"), or press the * button in the main interface to enter single call number, select "Radio activation", and
press the [MENU] button to start; "Radio activations successful" displays if it is successful, and "Radio activation
failed" displays if fails.

Receive radio activation:
After receiving the radio activation command, send activation tone, re-shutdown and then boot. It can also be
activated by writing frequency software.
Note: This function works only if the function is set and turned on by writing-frequency software.
■Radio remote kill
In digital mode, you can send a remote inhibit command to a contact, so that the radio can't be used normally.

Initiate remote kill:
Select single call contact (enter "Menu -> Contacts -> Press []/[] to select single call contact ->Radio inhibit"),
or press the * button in the main interface to enter single call number, select "Radio inhibit", and press the
[MENU] button to start; "Radio inhibit is successful" displays if it is successful, and "Radio inhibit failed" displays if
fails.

Receive remote kill:
After receiving the radio inhibit command, send inhibit prompt tone, and press the [PTT] button to display