Baofeng DM-1701 User Manual page 34

Read the scan list
1. Use the channel knob to choose a channel with pre-programmed scan list;
2.Press the【MENU】button to enter into the MENU mode;
3.Press the【】/【】button to scan, then press the【MENU】button to make a choice;
4.Press the【】/【】button to read the list, then press the【MENU】button to make a choice;
5.Use the【】/【】button to read every member in the list.
•
If you set the priority, the priority icon will be displayed to the left of member alias, that means this
member is priority 1 channel
icon will not displayed. Several priority 1 channel or priority 2 channels is not allowed in one scan list.
•
Or Select to delete a channel in the current scan list, but you cannot delete the first channel in the scan list.
Add scan channel
1.Press the【MENU】button to enter into the MENU mode.
2.Press the【】/【】button to scan, then press the【MENU】button to make a choice.
3.Press the【】/【】button to add channel, then press the【MENU】button to make a choice.
4.Press the【】/【】button to choose the required add channel, then press the【MENU】button to make a
choice.
5. The screen indicates "Success to add channel" and back to the upper menu automatically.
Scan instruction and method
The radio will check if there are any voice activities to the current channel by pre-program the scan list cycling.
The red LED indicator light flash and the scan icon
During the duplex mode scan period, if you are on a digital channel and your radio locks an analog channel,
the digital mode will be automatically switched to analog mode during the entire duration call.
There are two ways to scan:
• Manual scan: start to scan by pre-programming the scan turn on/turn off button or the menu function,
when start to scan, the radio will detect all the channels/group calls pre-set in the scan list.
• Automatically scan: when you choose a channel/group calls which have been activated, the radio will
start to scan from the automatically scanned channel.
Start and stop scan
Press the pre-programmed scan turn on/turn off button or enter into the scan menu function
1. Use the channel knob to choose a channel with pre-programmed scan list;
2.Press the【MENU】button to enter into the MENU mode;
3.Press the【】/【】button to scan, then press the【MENU】button to make a choice;
4. If the scan was stopped, the screen will indicate to open, or if the scan is activated, the screen will indicate to
close.
or priority 2 channels
will appear in the screen.
, and if the priority is set as , the