Baofeng DM-1701 User Manual page 46


Relay Station Time Slot
The relay time slot refers to the slot for voice communication or data transmission, which only can be modified
within the digital channels. Method of cooperating MENU:
1. Entering the menu via [MENU] button.
2. Press【】/【】to find SETTING, press [MENU] to confirm.
3. Press【】/【】to find CONFIGURATION, press [MENU] to confirm.
4. Input the correct configuration password (setting by programming), press [MENU] to confirm.
5. Press【】/【】to find Relay Station Time Slot, press [MENU] to confirm.
6. Press【】/【】to select the relay station time slot , then press [MENU] to confirm. The time slot selected
will be in the display.
The digital channel of host computer can be configured to dual capacity direct mode. This mode supports
parallel direct mode transmission of two two-way radios transmitting on 12.5KHz channel bandwidth. The radios
in the same communication group must use the same time slot, and the group using slot 1 will not interfere with
the group using slot 2.

VOX
The higher the level of VOX is, the lower the sensitivity is, and the louder the sound to trigger the VOX function is.
Method of cooperating MENU:
1. Entering the menu via [MENU] button.
2. Press【】/【】to find SETTING, press [MENU] to confirm.
3. Press【】/【】to find CONFIGURATION, press [MENU] to confirm.
4. Input the correct configuration password (setting by programming), press [MENU] to confirm.
5. Press【】/【】to find Color code, press [MENU] to confirm.
6. Press【】/【】to select the color code, then press [MENU] to confirm. The color code selected will be in
the display.
Please adjust the voice gain level correctly according to the current environment and normal speaking
volume, so as to avoid frequent accidental triggering (sensitivity too high) or difficult to trigger voice control
(sensitivity too low).
The sensitivity of voice control transmission can be modified by writing-frequency software, level 1 is the highest
sensitivity level, and level 10 is the lowest sensitivity level.
Transmitting contacts
Transmitting contactor only can be modified within the digital channels. Method of cooperating MENU:
1. Entering the menu via [MENU] button.
2. Press【】/【】to find SETTING, press [MENU] to confirm.
3. Press【】/【】to find CONFIGURATION, press [MENU] to confirm.
4. Input the correct configuration password (setting by programming), press [MENU] to confirm.
5. Press【】/【】to find transmitting contactor, press [MENU] to confirm.
Press 【 】 / 【 】 to select the contactor, then press [MENU] to confirm. The contactor selected will be in the
6.
display.

Group Call List
The group call list only can be modified within the digital channels. Method of cooperating MENU:
1. Entering the menu via [MENU] button.
2. Press【】/【】to find SETTING, press [MENU] to confirm.