Motomaster 011-1504-0 Instruction Manual page 12

12
model no. 011-1504-0 | contact us 1-800-528-6817
3. With the charger plugged in and connected to the battery of the vehicle, set the charge rate selector
switch (1) to the ENGINE START position (see Fig. E).
4. Crank the engine until it starts or 5 seconds pass. If the engine does not start, wait 4 minutes before
cranking again. This allows the battery and the charger to cool down.
5. If the engine fails to start, charge the battery for 5 more minutes before attempting to crank the engine
again 5 minutes before cranking the engine.
6. After the engine starts, unplug the AC power cord and then disconnect the battery clips from the vehicle.
7. Clean and store the charger in a dry location.
NOTE:
• During extremely cold weather, or if the battery is under 2 volts, charge the battery for 5 minutes
before cranking the engines.
• If the engine does turn over but never starts, there is not a problem with the starting system;
there is a problem somewhere else with the vehicle STOP cranking the engine until the other
problem has been diagnosed and corrected.
Fig. E
CHARGE
% 100
75 50
25 0
U L
1
MM-111504-05