Simodrive 611A Msd Or Simodrive 660 - Siemens SINUMERIK 840C Installation Instructions Manual

12 Functional Descriptions
12.24.5 Travel to fixed stop with programmable clamping torque
12.24.5.2

SIMODRIVE 611A MSD or SIMODRIVE 660

With these systems, the drive is switched over from torque-limited operation to torque-
controlled operation after the fixed stop is reached. In this way, a torque of any desired value
(0.1 to 99.9% of max. torque) can be specified via the setpoint interface.
Setpoints must be input via terminals 56/14.
Hardware connections:
NC
Measu-
ring
circuit
PLC
Outputs
Input
Functional sequence
The control must switch the spindle to C-axis operation before the function is selected. It does
this by activating terminal E1 (C-axis operation) of the drive actuator.
The NC detects selection of function G221 (via G function or command channel) during block
processing and informs the PLC that the function has been selected via the interface signal
TRAVEL TO FIXED STOP ACTIVE.
The PLC then activates the free gear stage, in which the torque limitation is operative, via
terminals 117, 118 and 119 and outputs the interface signal ACKNOWLEDGEMENT TRAVEL
TO FIXED STOP ACTIVE to the NC.
The rotary axis then starts to traverse at the programmed velocity.
As soon as the C axis has reached the fixed stop, the following error increases. As a result of
the increase in the following error above the threshold set in NC MD 1280* or owing to the
input signal of a sensor (which is passed on to the PLC-NC interface), the control detects that
the fixed stop has been reached.
12–250
611 MSD, 660
56
Speed
14
setpoint 1
1
24 Speed
8 setpoint 2
2
117
Gear stage
118
changeover
8
119
E1 C-axis operation
E1 Torque-controlled
operation
Sensor signal for
"Fixed stop reached"
(optional)
© Siemens AG 1992 All Rights Reserved
12.93
Po 39
1st torque
limitation
.
.
.
6FC5197- AA50
SINUMERIK 840C (IA)