Installing An Ergonomic Video Workstation; Connecting The Monitor - Fujitsu Siemens Computers 463V FA Operating Manual

Installing an ergonomic video workstation

Before you set up your equipment, you should select a suitable position for working at the monitor.
Please observe the following advice when installing a video workstation.
Avoid direct and reflected glare. Avoid glare from electric
preferable viewing sector
0°
0°
60°
permissible
viewing sector
permissible viewing sector
Position the monitor for
optimum viewing. The viewing
distance to the monitor should
be approximately 50 cm.
Depending on the situation, the use of a swivel arm or wall bracket (VESA FPMPMI), are available
from specialised dealers, may be advisable. For this purpose the monitor base must be removed
beforehand as described in chapter "Removing the monitor base".

Connecting the monitor

Please note the information provided in the "Safety" section in the chapter "Important
!
notes" at the beginning of this manual.
CE conformance and optimum picture quality are guaranteed only if you use the data
cable supplied.
Do not cover the ventilation openings of the monitor.
The computer power plug must be pulled out!
Ê
Be sure that the monitor and the computer are switched off.
A26361-K864-Z100-1-5E19
lighting.
65°
30°
30°
65°
Keep ventilated areas clear.
Colour monitor 463V FA
edge of desk
permissible permissible
reaching sector reaching sector
600 mm
Position the keyboard where it
is easiest to reach.
approx. 90°
approx. 90°
and more
Remember to maintain correct
posture.
English - 7
600 mm