Equipment Safety - Unimac UM-S1P User Manual

UM-S1P Electric High-Pressure Airless Paint Station

Equipment Safety

• It is highly recommendations to use the equipment with a residual current device (RCD) rated at 30mA
or less.
• Never spray flammable paints or solvents with a flash point below 21ºC.
• Never spray near a naked flame, including an appliance pilot light.
• Never smoke whilst spraying.
• Never allow children to operate or play with the spray gun.
• Never use the equipment outside if it is raining.
• Never immerse the spray gun in liquid. This could lead to electric shock, personal injury and material
damage.
• Always ensure there is adequate ventilation when spraying.
• Always wear a respirator and eye protection when spraying.
• Always read the paint manufacturer's instructions before using.
• Never allow the spray material to come in direct contact with the skin.
• Do not clean the equipment using flammable liquids with a flash point below 21ºC.
• Clean the equipment thoroughly after every use.
• Before cleaning, always disconnect the equipment from the mains supply.
• Do not point the spray gun at yourself or any other person or animal. Injury from penetration of the skin
and paint or solvents being injected into the body can result. If injury from paint or solvent injection into
the skin or body occurs, seek medial attention immediately and advise the paints or solvents used.
• Always check hose connections for leaks, and for correct equipment operation before use. Never
operate the equipment if there are any leaks or faults – seek diagnosis and repair before using the
equipment.
• Release pressure in the equipment when finished spraying. Pressure can remain in the unit and hose
when switched off.
E&OE ©2018 Unimac 6