Cleaning; Inlet Hose And Filter - Unimac UM-S1P User Manual

UM-S1P Electric High-Pressure Airless Paint Station

Cleaning

Perform the
cleaning procedure carefully as a build-up of dried paint on the operating components can
stop the unit from working. • Always use the appropriate cleaner for the paint in use (water for acrylics,
mineral turpentine for enamels etc). •
failing to properly clean and maintain the equipment is NOT covered under

Inlet Hose and Filter

1. Remove the inlet hose from the coating material
then switch the machine on.
3. Place the inlet hose into a bucket of appropriate
cleaner.
5. Rotate the pressure valve left (anti-clockwise)
until fully out, then switch the unit on and wait 30
seconds.
E&OE
pressure release procedure
Equipment failure, poor operation or unsatisfactory results from
©2018 Unimac
before starting the cleaning procedure. Follow the
warranty.
2. Wait for paint to stop running out of return hose
then switch the machine off.
4. Rotate the spray tip to the "clean" setting (arrow
pointing backward).
6. Set spray valve to the "spray" setting (lever
forward).
16