Other Uses Of The Paint Sprayer; Maintenance And Cleaning; Paint Sprayer; Nozzle And Needle - Unimac HVLP User Manual

Electric HVLP Paint Sprayer

Other Uses of the Paint Sprayer

By connecting the fitting to the hose, the paint sprayer can also be used to blow or inflate mattresses or other
inflatable objects.

Maintenance and Cleaning

The paint sprayer must be thoroughly cleaned immediately after use. If the paint dries inside the paint sprayer,
cleaning will be much more difficult and it may no longer be possible use the paint sprayer. Use the thinner (or
solvent) recommended by the paint manufacturer and clean the paint sprayer in a well ventilated room. Follow
the safety instructions as described:

Paint Sprayer

1. Disassemble the paint sprayer reservoir.
2. Pour any residual paint into its container and seal it so that it can be used in the future.
3. Pour the thinner (in small amounts) into the reservoir. Shake the paint sprayer lightly and atomise the thinner
into a cleaning container. Repeat the operation until the thinner being sprayed is completely clean.
4. Clean off any traces of paint, both inside and outside the reservoir.
5. Clean the gasket located under the reservoir cover.

Nozzle and Needle

1. Unscrew the ring.
2. Remove the butterfly nozzle.
3. Completely loosen the adjustment screw.
4. Remove the plain washer.
5. Completely loosen the adjustment screw.
6. Remove the spring.
7. Push out the needle; it is recommended not to use tools.
8. Put all these pieces in a container and clean them using a brush and a clean thinner.
9. The inside of the paint sprayer and the hose should also be cleaned.
10. Before replacing these parts, they must be thoroughly dried using the multistage centrifugal blower.
WARNING!
Reassemble the parts by reversing the sequence of operations described above. In
particular, it is recommended to mount the internal nozzle BEFORE the needle.
5