Assemble The Removable Terminal Block And The Housing; Install The Removable Terminal Block Onto The Module - Allen-Bradley ControlLogix 1756-OV32E Installation Instructions Manual

ControlLogix DC (10-30V) Electronically-Fused Sinking Current Output Module 11

Assemble the Removable Terminal Block and the Housing

1. Align the grooves at the bottom of the housing with the side edges of the RTB.
Groove
Side edge of the RTB
2. Slide the RTB into the housing until it snaps into place.

Install the Removable Terminal Block onto the Module

If you connect or disconnect wiring while the field-side
WARNING
power is on, an electrical arc can occur. This could cause
!
an explosion in hazardous location installations.
Before proceeding with RTB installation, make certain:
• power is removed or the area is nonhazardous.
• field-side wiring of the RTB has been completed.
• the RTB housing is snapped in place on the RTB.
• the RTB housing is closed.
• the locking tab at the top of the module is unlocked.
1. Align the side and top, bottom guides.
RTB guides
Groove
2. Press quickly and evenly to seat the RTB
Module
guide
Allen-Bradle
20853–M
3. Slide the locking tab down.
Publication
Side edge of the RTB
until the latches snap into place.
1756-IN582A-EN-P - August 2003
20852-M
Locking tab
20854–M