Connect The Fiber Cable - Allen-Bradley ControlNet 1786-RPFM Installation Instructions Manual

Connect the Fiber Cable

If you are going to use only one channel, use either Channel 1 or Channel 2.
To connect the cable for Channel 1:
1. Connect to Channel 1 Receive (RX).
a. Align the knob of the cable connector with the groove of the module
connector, and insert the connector into Channel 1 RX.
Figure 4 Connect the Fiber Cable
b. Twist the Receive connector until the bayonet lug is locked into place
2. Connect to Channel 1 Transmit (TX), repeat Step 1.
To connect the fiber cable to Channel 2:
1. Repeat the steps for Channel 1 and refer to the following figure.
ControlNet Modular Repeater Medium Distance Fiber Module
30044-M
Publication 1786-IN011B-EN-P - October 2000
13