Remove The Repeater Module From The Din Rail; Connect The Repeater Module - Allen-Bradley ControlNet 1786-RPCD Installation Instructions Manual

Remove the Repeater Module from the DIN Rail

To remove the module from the DIN rail, do the following:
1. Insert a screwdriver into the module locking tab.
2. Gently pry up on the locking tab.
The module should detach from the DIN rail. If the module does not unlock, try
more pressure while you pry up on the locking tab with the screwdriver.

Connect the Repeater Module

If you need to connect only one coax channel on the 1786-RPCD module,
TIP
you can use either channel 1 or channel 2. Both channels 1 and 2 operate
identically and can be used interchangeably.
Be sure to terminate the unused channel with a 75-
(1786-XT).
ControlNet Dual Copper Repeater Module
Ω
Publication 1786-IN001B-EN-P - May 2004
31491-M
terminating resistor
13