Allen-Bradley MicroLogix 1200 Installation Instructions Manual page 9

Analog output module

Hide thumbs Also See for MicroLogix 1200:

Table of Contents

Terminal Block Layout

Differential Sensor Transmitter Types

Current Load

Voltage Load

TIP

Labeling the Terminals

A write-on label is provided with the module. Mark the identification of each terminal with

permanent ink, and slide the label back into the door.

V out 0

I out 0

V out 1

I out 1

V out 2

I out 2

V out 3

I out 3

COM

Grounding the cable shield at the module end only usually provides

sufficient noise immunity. However, for best cable shield

performance, earth ground the shield at both ends, using a 0.01 µF

capacitor at one end to block AC power ground currents, if

necessary.

MicroLogix™ 1200 Analog Output Module

Commons connected

internally.