Allen-Bradley MicroLogix 1200 Installation Instructions Manual page 17

Specification
Electrical /EMC:
ESD Immunity (EN61000-4-2)
Radiated Immunity (EN61000-4-3)
Fast Transient Burst (EN61000-4-4)
Surge Immunity (EN61000-4-5)
Conducted Immunity (EN61000-4-6)
(1) The over- or under-range flag comes on when the normal operating range (over/under) is exceeded. The module continues to
convert the analog output up to the maximum full scale range.
(2) Repeatability is the ability of the output module to reproduce output reading when the same controller value is applied to it
consecutively, under the same conditions and in the same direction.
(3) Rated working voltage is the maximum continuous voltage that can be applied at the terminals with respect to earth ground.
(4) Conducted Immunity frequency range may be 150 kHz to 30 MHz if the Radiated Immunity frequency range is 30 MHz to
1000 MHz.
Output Specifications
Specification
Number of Outputs
D/A Converter Type
Module Update Time
Resistive Load on Current Output 0 to 500 Ω (includes wire resistance)
Load Range on Voltage Output
Reactive Load, Current Output
Reactive Load, Voltage Output
(1)
Typical Overall Accuracy
Output Ripple
range 0 to 500 Hz
(referred to output range)
Non-linearity (in percent full scale) < ±0.5%
Open and Short-Circuit Protection Continuous
Output Protection
(1) Includes offset, gain, non-linearity and repeatability error terms.
MicroLogix™ 1200 Analog Output Module
Value
The module has passed testing at the following levels:
4 kV contact, 8 kV air, 4 kV indirect
10 V/m, 80 to 1000 MHz, 80% amplitude modulation, +900 MHz
keyed carrier
2 kV, 5 kHz
1 kV galvanic gun
10V, 0.15 to 80 MHz
Value
4 single-ended (bipolar)
R-2R Ladder Voltage Switching
2.5 ms
> 1KΩ
< 0.1 mH
< 1 µF
±1% full scale at 0 to 55°C
±0.5% full scale at 25°C
< ±0.1%
±32 mA
AB Spares
(4)
Publication 1762-IN016A-EN-P - July 2003
17