Allen-Bradley MicroLogix 1200 Installation Instructions Manual page 6

6 MicroLogix™ 1200 Analog Output Module
Use DIN rail end anchors (Allen-Bradley part number 1492-EA35 or 1492-EAH35) for
environments with vibration or shock concerns.
TIP
Panel Mounting
Use the dimensional template shown below to mount the module. The preferred mounting
method is to use two M4 or #8 panhead screws per module. M3.5 or #6 panhead screws may
also be used, but a washer may be needed to ensure a good ground contact. Mounting screws
are required on every module.
For more than 2 modules: (number of modules - 1) x 40.4 mm (1.59 in.)
Publication 1762-IN016A-EN-P - July 2003
End Anchor
For environments with extreme vibration and shock concerns, use
the panel mounting method described below, instead of DIN rail
mounting.
100 90
(3.94) (3.54)
40.4
14.5
(1.59)
(0.57)
40.4
(1.59)
End Anchor
NOTE:
Hole spacing tolerance:
±0.4 mm (0.016 in.).