Advertisement
Vision Software Installation
19
3
Machine Setup
On the rear of the Phoenix 1212, there are three connection ports. The power cord, the USB port, the RJ-
45 ethernet port, and the remote on/off port for optional equipment.
Phoenix 1212 (rear view)
Connect the power cord to a 110 - 220 VAC source, then plug the power cable into the port on the back
of the machine. Plug in the network cable (or the crossover cable) to the back of the machine and either
plug the network cable into your network, your hub, or using the crossover cable, plug into the network
port on the back of your computer.
NOTE: The Ethernet crossover cable is gray and should not be needed.
If the emergency stop screen appears on the LCD when the machine is powered on, then the emergency
stop button is pressed in. Release the button twisting it until it "pops up". This will clear the emergency
stop screen.
© 2018 Vision Engraving & Routing Systems
Advertisement
