Index - National Instruments IMAQ PCI-1408 Getting Started

Numbers
+5V signal (table), 4-3
8-bit ADC and LUT, 3-3
A
acquisition and region-of-interest control, 3-4
acquisition modes, 3-10
acquisition window
controlling, 3-6 to 3-8
programming video parameters, 3-9
active line region, 3-7
active pixel region, 3-7
A/D conversion specifications, A-2
ADC, 8-bit, 3-3
Advanced Panel (1),
Advanced Panel (2),
Advanced Panel (3),
antichrominance filter, 3-2
AutoSnap menu,
IMAQconf
B
Basic Settings panel,
BNC connector
avoiding VIDEO0 connection with 25-pin
DSUB connector (note), 4-1
pin assignments (figure), 4-1
signal connections, 4-1
VIDEO0 input, 2-2
board configuration. See configuration.
bulletin board support, C-1
© National Instruments Corporation
, 5-10 to 5-12
IMAQconf
, 5-12 to 5-13
IMAQconf
, 5-13 to 5-14
IMAQconf
, 5-4
, 5-7 to 5-9
IMAQconf
C
cables
custom cable specifications, B-1
optional equipment, 1-5 to 1-6
required cables, 1-2
Camera Acquisition panel,
5-9 to 5-10
Camera Type panel,
composite synchronization. See CSYNC.
configuration, 2-1 to 2-4. See also installation.
board configuration NVRAM, 3-5
external CLK and synchronization input
mode, 2-3
parts locator diagram, 2-2
setting up IMAQ system, 1-6 to 1-7
Switch S1, 2-4
VIDEO0 input mode, 2-2 to 2-3
configuration utility. See
configuration utility.
CSYNC
acquisition window control, 3-6
CSYNC mux, 3-3
external acquisition mode, 3-10
external CLK and synchronization input
mode, 3-3
CSYNCIN± signal (table), 4-3
CSYNCOUT signal (table), 4-3
custom cable specifications, B-1
customer communication, xi, C-1 to C-2
I-1

Index

,
IMAQconf
, 5-6 to 5-7
IMAQconf
IMAQconf
PCI-1408/NI-IMAQ for Mac OS