Using The Fs-Gui To Set The Ip Address; Accessing Smc Cloud; Figure 9: Fs-Gui Network Settings - SMC Networks FieldServer FS-QS-2X10 Quickserver Start-Up Manual

5.1.2 Using the FS-GUI to Set the IP Address

•
From the FS-GUI main home page, click on setup and then Network Settings to enter the Edit IP
Address Settings menu.
•
Modify the IP Address (N1 IP Address field) of the QuickServer Ethernet port.
•
If necessary, change the Netmask (N1 Netmask field).
•
Type in a new Subnet Mask.
•
If necessary, change the IP Gateway (Default Gateway field).
•
Type in a new IP Gateway.
NOTE: If the FieldServer is connected to a router, the IP Gateway of the FieldServer should be set
to the same IP Address of the router.
•
Click Update IP Settings, then click on the System Restart to restart the Gateway and activate the
new IP Address.
NOTE: If the FS-GUI was open in a browser, the browser will need to be pointed to the new IP
Address of the QuickServer before the FS-GUI will be accessible again.

5.1.3 Accessing SMC Cloud

The FieldPoP™ button
Monitor's device cloud solution for IIoT. The SMC Cloud enables secure remote connection to field
devices through a FieldServer and its local applications for configuration, management, maintenance. For
more information about the SMC Cloud, refer to the

Figure 9: FS-GUI Network Settings

Figure 9) allows users to connect to the SMC Cloud, Sierra
(see
SMC Cloud Start-up
Page 14 of 34
QuickServer Start-Up Guide
Guide.