Using The Fs-Gui To Set The Ip Address; Accessing Smc Cloud; Figure 9: Fs-Gui Network Settings - SMC Networks FieldServer FS-QS-2XX0 Quickserver Start-Up Manual

5.1.2 Using the FS-GUI to Set the IP Address

•
From the FS-GUI main home page, click on setup and then Network Settings to enter the Edit IP
Address Settings menu.
•
Modify the IP Address (N1 IP Address field) of the QuickServer Ethernet port.
•
If necessary, change the Netmask (N1 Netmask field).
•
Type in a new Subnet Mask.
•
If necessary, change the IP Gateway (Default Gateway field).
•
Type in a new IP Gateway.
NOTE: If the FieldServer is connected to a router, the IP Gateway of the FieldServer should be set
to the same IP Address of the router.
•
Click Update IP Settings, then click on the System Restart to restart the Gateway and activate the
new IP Address.
NOTE: If the FS-GUI was open in a browser, the browser will need to be pointed to the new IP
Address of the QuickServer before the FS-GUI will be accessible again.

5.1.3 Accessing SMC Cloud

The SMC Cloud button
Sierra Monitor's device cloud solution for IIoT. The SMC Cloud enables secure remote connection to field
devices through a FieldServer and its local applications for configuration, management, maintenance. For
more information about the SMC Cloud, refer to the

Figure 9: FS-GUI Network Settings

Figure 9) allows users to connect to the SMC Cloud,
(see
SMC Cloud Start-up
Page 13 of 32
QuickServer Start-Up Guide
Guide.