Connecting To Dc Power; Plugs And Pin-Outs - Cisco IR800 Series Hardware Installation Manual

Connecting to DC Power

2. To communicate with the router, wait for your laptop or PC to discover the new device.
3. If your laptop or PC warns you that you do not have the proper drivers to communicate with the router,
you can obtain them from your computers manufacturer, or go here:
https://www.silabs.com/products/mcu/Pages/USBtoUARTBridgeVCPDrivers.aspx
Note: If you are connecting to the USB port:
•
Figure 8: Connecting a Terminal or PC to the Console Port
Connecting to DC Power
WARNING: This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure
that the protective device is rated not greater than 10A Statement 1005
WARNING: This product requires short-circuit (overcurrent) protection, to be provided as part of the building
installation. Install only in accordance with national and local wiring regulations. Statement 1045
WARNING: Connect the unit only to DC power source that complies with the safety extra-low voltage
(SELV) requirements in IEC 60950 based safety standards. Statement 1033.

Plugs and Pin-Outs

The IR807 ships with a DC power accessory kit.
The power entry receptacle is on the IR807. The pin-outs are shown in
on page
Cisco IR807 Industrial Integrated Services Router Hardware Installation Guide
36
• - a connection (to the USB port) can only be made in a non-hazardous environment
• - the USB port cover must be reinstalled before the router can be deployed in a hazardous environment
37.
Connecting the Router
Figure 9: Power Connector Pin-Outs,