Table of Contents
Advertisement
Preface
Safety Warnings
Danger
WARNING: When installing the product, please use the provided or designated connection cables/power
cables/AC adapters. Using any other cables/adapters could cause a malfunction or a fire. Electrical Appliance
and Material Safety Law prohibits the use of UL-certified cables (that have the "UL" shown on the code) for
any other electrical devices than products designated by CISCO. The use of cables that are certified by Electrical
Appliance and Material Safety Law (that have "PSE" shown on the code) is not limited to CISCO-designated
products. Statement 371
WARNING: Read the wall-mounting instructions carefully before beginning installation. Failure to use the
correct hardware or to follow the correct procedures could result in a hazardous situation to people and damage
to the system. Statement 378
WARNING: To avoid electric shock, do not connect safety extra-low voltage (SELV) circuits to
telephone-network voltage (TNV) circuits. LAN ports contain SELV circuits, and WAN ports contain TNV
circuits. Some LAN and WAN ports both use RJ-45 connectors. Use caution when connecting cables. Statement
1021
WARNING: T his equipment must be grounded. Never defeat the ground conductor or operate the equipment
in the absence of a suitably installed ground conductor. Contact the appropriate electrical inspection authority
or an electrician if you are uncertain that suitable grounding is available . Statement 1024
WARNING: If the symbol of suitability with an overlaid cross appears above a port, you must not connect
the port to a public network that follows the European Union standards. Connecting the port to this type of
public network can cause severe personal injury or can damage the unit. Statement 1031
WARNING: Connect the unit only to DC power source that complies with the safety extra-low voltage
(SELV) requirements in IEC 60950 based safety standards. Statement 1033
WARNING: For connections outside the building where the equipment is installed, the following ports must
be connected through an approved network termination unit with integral circuit protection: 10/100/1000
Ethernet. Statement 1044
WARNING: When installing or replacing the unit, the ground connection must always be made first and
disconnected last. Statement 1046
WARNING: Do not locate the antenna near overhead power lines or other electric light or power circuits, or
where it can come into contact with such circuits. When installing the antenna, take extreme care not to come
into contact with such circuits, because they may cause serious injury or death. For proper installation and
grounding of the antenna, please refer to national and local codes (for example, U.S.:NFPA 70, National
Electrical Code, Article 810, Canada: Canadian Electrical Code, Section 54). Statement 1052
WARNING: No user-serviceable parts inside. Do not open. Statement 1073
WARNING: Installation of the equipment must comply with local and national electrical codes. Statement
1074
WARNING: Only trained and qualified personnel should be allowed to install, replace, or service this
equipment. Statement 1030
WARNING: Read the installation instructions before connecting the system to the power source. Statement
1004
Cisco IR807 Industrial Integrated Services Router Hardware Installation Guide
7
Advertisement
Table of Contents
