Table of Contents
Advertisement
Installing the Router
• Sierra Wireless WP7xxx modem series supports SIMO on LTE. WCDMA UMTS HSPA DC-HSPA+
• The IR807 must be installed with 2 antennas (Main & Aux) to guarantee the best performance level.
• In case of 3G UMTS, a solo antenna would not be able to switch to the diversity port.
Mounting on a Wall, Table, or Other Flat Surface
The Cisco IR807 can be mounted in a vertical or horizontal orientation. It can be mounted to a wall or other
flat surface, and can also be mounted to a DIN rail.
TIP: When choosing a location for wall-mounting the router, consider cable limitations and wall structure.
WARNING: Read the wall-mounting instructions carefully before beginning installation. Failure to use the
correct hardware or to follow the correct procedures could result in a hazardous situation to people and damage
to the system. Statement 378
To mount the router on a wall or other flat surface, follow these steps:
1. Mark the location for the mounting brackets to attach to the wall. The dimensions are described in
4: Wall Mount Dimensions, on page
Figure 4: Wall Mount Dimensions
NOTE: For hollow-wall mounting, each bracket requires two wall anchors with washers. Wall anchors and
washers must be size number 10.
1. Attach the mounting brackets to the bottom of the router.
2. Align the mounting brackets over the mounting holes so that the larger holes on the brackets extend out
over the router.
3. Attach the brackets to the router with the 4 screws provided using a Phillips head driver. Torque to 13-15
in-lbs.
is diversity only, without SIMO.
Using a single antenna may impact downlink performance by a minimum of 3dB, and can be much more
(10-20dB) due to multipath fading (destructive interference between direct and reflected radio waves).
Cisco IR807 Industrial Integrated Services Router Hardware Installation Guide
Mounting on a Wall, Table, or Other Flat Surface
29.
Figure
29
Advertisement
Table of Contents
