MCi Reliability Driven Series Operator's Manual page 37

TO LOAD PASSENGER:
1. Load passenger onto platform, lock wheelchair
brakes.
2. Latch handrail belt.
3. Press UP switch on the pendant to fold outer
barrier up. Raise platform to floor level. At
coach floor level, the inner roll stop will
automatically unfold as a ramp.
4. Carefully unlock wheelchair brakes and unload
passenger from platform.
5. Position and securely restrain wheelchair in the
wheelchair parking area using the proper
restraints.
TO UNLOAD PASSENGER:
1. Latch handrail belt.
2. Press UP button on the pendant until lift stops
(raises to floor level), and inner roll stop unfolds
to floor level.
3. Carefully load passenger onto platform and lock
wheelchair brakes.
4. Latch handrail belt.
5. Press DOWN button on the pendant until entire
platform reaches ground level and outer barrier
unfolds fully.
6. Unlatch handrail belt, unlock wheelchair brakes
and unload passenger from platform.
TO STOW PLATFORM:
1. Press STOW button on the pendant until
platform reaches stow level (stops).
2. Using strap, lift center transition plate and push
outer barrier in fully.
3. Manually stow (fold) platform to vertical
position.
4. Support platform with right hand and rotate
yellow platform latch to Unlock position (up).
5. Push platform in and rotate yellow platform
latch to Lock position.
July 2015
TO STOW HANDRAILS:
1. Lift the LH handrail and swing in.
2. Lower handrail to locked position.
3. Lift the RH handrail and swing in.
4. Lower handrail to locked position.
Ensure handrails are locked together
(Figure 41.).
Figure 41.
TO STOW LIFT (IN):
1. Press STOW button until lift stops (retracts
fully).
2. Release the cabin door by placing the LOCK/
UNLOCK switch at the end of the heat duct to
UNLOCK.
The cabin door must be closed before the lift
key is switched OFF. This action controls both
the pneumatic door locks as well as providing
power to the lift.
3. Press POWER switch to OFF.
4. Store hand-held pendant in lift storage clip.
5. Remove pin from lower door hinge. Insert pin in
storage clip.
6. Close door.
7. Turn wheelchair lift key switch on the lower, LH
switch pane to OFF.
35