MCi Reliability Driven Series Operator's Manual page 35

BRAUN WHEELCHAIR LIFT OPERATION
1. Stop the coach, ensuring that there is adequate
clearance to deploy the lift and to allow the
passenger to maneuver onto the platform.
2. Place the transmission in Neutral and set the
Park Brake.
3. Turn ON the wheelchair lift master switch key
on the lower, LH switch panel (Figure 31.). The
alarm will sound and the WCL INTRLK dash
telltale in the RH telltale cluster will illuminate.
Figure 31. WCL Master Switch
4. Fold and position passenger sliding seats to
provide wheelchair parking area.
5. Remove the key and exit the coach.
6. Open the wheelchair lift compartment door.
Place the steel pin through the two holes,
securing the door in the open position
Figure 32.
1. WCL control pendant
2. Pin location
July 2015
Deploying The Lift From Compartment
7. Lift to remove control pendant from lift storage
clip.
8. Press POWER switch on the pendant to ON
(POWER button illuminates only when the lift is
operating and receiving power).
Figure 33. Braun WCL Pendant
1. Up Button
2. Down Button
3. Stow Button
4. Power Enable Switch4
9. Stand clear. Press and hold the UP switch until
lift stops (extends fully).
10. Lift the RH handrail and swing out. Lower the
handrail to the locked position.
11. Lift the LH handrail and swing out. Lower the
handrail to the locked position
12. Securely support platform with right hand and
rotate yellow platform latch (Figure 34.) up to
Unlock platform.
Figure 34.
33