MCi Reliability Driven Series Operator's Manual page 29

CRUISE CONTROL
Do not use cruise control in heavy traffic, on
icy roads or in any other driving condition
that does not permit a constant speed.
Setting Vehicle Speed
Press the ON switch to turn on the cruise control.
Accelerate to the desired speed, press the Set
switch, then release the accelerator pedal. The
CRUISE ENABLED telltale on the RH cluster stays
on until the cruise control is turned off.
Note: Cruise control will not operate under 20
mph (32 km/h).
Increasing Set Speed
1. Press and hold the RES switch until the desired
speed is reached,
OR
2. Press the accelerator pedal until the desired
speed is reached, then press and release the SET
switch.
NOTE: When driving with cruise control, speed
may be increased (for passing, etc.) by
pressing the accelerator in the usual way.
Releasing the accelerator returns the coach to
the set speed.
Decreasing Set Speed
1. Press and hold the Set switch until the desired
speed is reached,
OR
2. Lightly press the brake to disengage the
system. Allow the vehicle to coast to the desired
speed, then press and release the Set switch.
NOTE: The transmission may be shifted in the
normal way without disengaging the cruise
control.
Canceling the Set Speed
1. Press the OFF switch or the CANCEL button,
OR
2. Make a slight brake application.
NOTE: When automatic operation is canceled,
Res may be used to return to cruise control.
July 2015
Figure 25.
JACOBS (JAKE) ENGINE BRAKE
The Jake brake controls are mounted on the RH
side of the steering wheel.
The four controls are: OFF, LOW, MEDIUM and
HIGH.
Figure 26.
The button located at the top of the RH control
features a "courtesy light" that momentary flashes
the coach marker lights to acknowledge passing
vehicles.
27