Table of Contents
Advertisement
1MRS750881-MUM
Remote Monitoring and Control Unit
Technical Reference Manual
Event Mask1 and Event Mask2
In addition to the application-dependent filter 1 mask, the event is reprocessed
through the LonMark mask. The masks are defined so that the setting of the bit
2^(event number) enables the event to be processed as a data event and sent out on
the network variable output defined in the next column. Several bits may be set in
the masks.
If the Protocol Editing Tool is used for the creation of the LonMark POD, the
selection of events to be processed as data events is done by selecting them from the
Event Mask E0-E31 and Event Mask E32-E63 lists.
Output Network Variable name
The name is given in ASCII format and must be exactly as defined below.
Nv indexes 68...77 are defined as "LM_STA_1", "LM_STA_2",..."LM_STA10".
Nv indexes 78...87 are defined as "LM_CNT_1", "LM_CNT_2",..."LM_CNT10".
Nv indexes 88...97 are defined as "LM_ANA_1", "LM_ANA_2",..."LM_ANA10".
Conversion rules (see appropriate application documentation for event value
types)
Event value types for output variables "LM_STA_1"..."LM_STA10" are the
following:
EV_1BIT
EV_2BIT
EV_3BIT
EV_INT16
Event value type for output variables "LM_CNT_1"..."LM_CNT10" is:
EV_FLOAT
Event value types for output variables "LM_ANA_1"..."LM_ANA10" are the
following:
EV_32BIT
EV_INT32
Process data object name
This is the definition of the internal source for momentary reading of process data.
The data can be found in the user's manual of the application. The name of the
process data object is always of format "Fxxx<D>yyy", where:
• "xxx" is the application ID
• "<D>" is the data category
• "yyy" is the data number
The name is an ASCII string with the fixed length of 8 characters.
If, for example, the converted data is an analogue current value I3 and the
application block is numbered 234, the name is "F234I003".
REC 523
57
Advertisement
Table of Contents
