Adjusting The Transport Rollers; Mounting The Verticutter Reel - Toro Reelmaster 3100-D Series Operator's Manual

Figure 10
1. Front roller scraper
2. Rear roller scraper
2. Move the scraper rods in or out to attain 0.0 to 0.75
mm (0.0 to 0.03 inch) clearance between the scraper
and roller.
3. Ensure that the scraper rod is parallel to the roller and
to the level surface.
4. Tighten the flange nuts to lock the adjustment.
7
Adjusting the Transport
Rollers
No Parts Required
Procedure
Before the verticutters are lowered to the shop floor or
removed from the traction unit, lower the transport rollers
(Figure 10) to protect the blades from hard surface contact.
1. Remove the cotter pin that secures the transport roller
bracket to the side plate pin.
2. Position the transport roller as follows:
•
Lower the roller bracket before the verticutter is
lowered to the shop floor.
•
Raise the roller bracket after the verticutter is raised
to the operating position.
3. Secure the transport roller bracket to the side plate pin
with the cotter pin.
4. Repeat the procedure on the opposite end of the
verticutter.
g012271
3. Transport roller
4. Cotter pin
8

Mounting the Verticutter Reel

No Parts Required
Procedure
Important: When lowering the verticutter reels, care
must be taken to prevent damage to the reel blades due
to contact with a concrete floor or a paved surface. Lower
the transport rollers before lowering the verticuttiers to
a concrete floor or a paved surface.
Figure 11 shows the orientation of the hydraulic drive motor
for each of the locations.
Verticutter reels are mounted to traction unit the same way
cutting units are. Refer to the traction unit Operator's Manual
for mounting instructions.
1. Verticutter 1
2. Verticutter 2
3. Verticutter 3
8
Figure 11
4. Weight
5. Reel motor
g196714