Adjusting The Rear Grass Shield; Adjusting The Roller Scrapers; Adjusting The Transport Rollers - Toro Reelmaster 5010-H Series Operator's Manual

7
Adjusting the Rear Grass
Shield
No Parts Required
Procedure
Note: When operating in turf conditions where much debris
or unusually heavy thatch is encountered, open the rear
discharge shield to help allow the debris to discharge from
the reel.
1. Loosen the bolts on the pivot of the grass shield
(Figure 10).
Figure 10
1. Rear grass shield
2. Rotate the grass shield to the desired setting, and
tighten the bolts (Figure
CAUTION
Do not open the rear shield so that it is higher than
level to ground.
Thrown debris could cause personal injury.
2. Pivot bolt
10).
8

Adjusting the Roller Scrapers

No Parts Required
Procedure
1. Loosen the flange nuts that secure the roller scrapers
(Figure 11).
1. Front roller scraper
2. Rear roller scraper
2. Move the scraper rods in or out to attain 0.0 to 0.75
mm (0.0 to 0.03 inch) clearance between the scraper
and roller.
3. Ensure that the scraper rod is parallel to the roller and
to the level surface.
4. Tighten the flange nuts to lock the adjustment.
9
Adjusting the Transport
Rollers
No Parts Required
Procedure
Before the verticutters are lowered to the shop floor or
removed from the traction unit, lower the transport rollers
(Figure 11) to protect the blades from hard surface contact.
1. Remove the cotter pin that secures the transport roller
bracket to the side plate pin.
2. Position the transport roller as follows:
9
Figure 11
3. Transport roller
4. Cotter pin