nifty 170SD series Operating/Safety Instructions Manual page 10

2.1.8
Never exceed the maximum platform capacity, as indicated on the decals and machine serial plate.
2.1.9
Only operate the Niftylift on a firm, level surface.
2.1.10
Never position any part of the Niftylift within 4.0m, (12ft) not exceeding 66kV. (Minimum span
125m) Other distances for increased voltages and different spans are given in NZECP 34:1993
2.1.11
On entering the platform, ensure that the drop down entry bar is closed afterwards.
2.1.12
Use of an approved safety belt and lanyard, hard hat and appropriate safety clothing is mandatory.
Fasten harness to designated harness securing points within the platform and do not remove until
leaving the platform whilst in the stowed position.
2.1.13
2.1.14
Do not use the platform levelling system to artificially increase the outreach of the platform. Never
use boards or ladders in the platform to achieve the same result.
2.1.15
Do not use the platform to lift overhanging or bulky items which may exceed the maximum capacity
or carry objects which may increase the wind loading on the platform.
2.1.16
The Niftylift shall not be operated from a position on trucks, trailers, railway cars, floating vessels,
scaffolds or similar equipment unless the application is approved in writing by Niftylift Ltd in Great
Britain.
2.1.17
Before lowering or slewing, always check below and around the platform to ensure that the area is
clear of personnel and obstructions. Care should be taken when slewing out into areas where there
may be passing traffic. Use barriers to control traffic flow or prevent access to the machine.
2.1.18
Stunt driving and horseplay, on or around the Niftylift, shall not be permitted
2.1.19
When other moving equipment and vehicles are present, special precautions shall be taken to
comply with local ordinances or safety standards established for the work place. Warnings such as,
but not limited to flags, roped off areas, flashing lights and barricades shall be used.
2.1.20
Before and during driving while the platform is elevated the operator shall maintain a clear view of
the path of travel, maintain a safe distance from obstacles, debris, drop offs, holes, depressions,
ramps and other hazards to ensure safe elevated travel. Maintain a safe distance from overhead
obstacles.
English/USA 09/03
THIS MACHINE IS NOT INSULATED.
If in doubt, contact the appropriate authorities
Always remain standing within the platform. Do not attempt to increase your
height or reach by standing and/or climbing on the platform guard rails or
any other object. KEEP YOUR FEET ON THE PLATFORM FLOOR. Do not
sit, stand or climb on the guard rail, mid rail or boom linkage. Use of planks,
ladders or any other devices on the Niftylift for achieving additional height or
reach shall be prohibited.
Operating & Safety Instructions
.
SD Series
8