Table of Contents
Advertisement
12.1 BIuetooth
pairing
®
Make sure that your Bluetooth
is on and Bluetooth is activated.
• Enable Bluetooth
operating mode on the radio by
®
repeatedly pressing [MODE]:
Press and hold
• Open the Bluetooth
settings on your terminal device
®
and wait until DIT1000MBT appears in the list of
Bluetooth devices found.
• If necessary, start searching for Bluetooth
on your terminal device.
• Select DIT1000MBT and wait until the radio is
listed as connected in the Bluetooth
your terminal device.
• Your terminal device is also shown as connected
on the radio display.
• Start and control audio playback using the
controls of the terminal device.
Note – Bluetooth
Some terminal devices require a password in order
to connect to another Bluetooth
• If your terminal device requests a password for
connection to the radio, enter 0000.
12.2 Automatic Bluetooth
(after successful pairing)
• Terminal devices already paired with the radio are
automatically saved on the radio.
• If you are pairing the terminal device with the
radio for the first time, proceed as described in
12.1. BIuetooth
pairing.
®
• Make sure that your Bluetooth
device is on and Bluetooth is activated.
• Press [MODE] repeatedly until the terminal device you
would like to pair with the radio is shown on the display.
• The devices will be automatically connected.
• If necessary, open the Bluetooth
terminal device and select DIT1000MBT.
• Start and control audio playback using the controls
of the terminal device.
capable terminal device
®
[MODE]
devices
®
settings on
®
password
®
device.
®
connection
®
capable terminal
®
setting on your
®
Note – Connection impaired
After the radio and terminal device have been paired, a
connection is established automatically. If the Bluetooth
connection is not established automatically, check the
following:
• Check the Bluetooth
to see whether DIT1000MBT is connected. If not,
repeat the steps listed under Bluetooth
• Check whether your terminal device and the radio
are less than 10 metres apart. If not, move them
closer togehter.
• Check whether obstacles are impairing the range.
If so, move the devices closer together.
13. Sleep
The radio has a sleep function, after a defined time the
radio switches to standby mode.
• Repeatedly press
[SLEEP]
the desired time interval (Sleep OFF/15/30/45/60/90/120
minutes).
Alternatively, set the time interval from the main menu:
• After the defined time the radio switches to
standby mode.
• Press
[
], to turn the radio back on.
• If a time interval is already activated, you can change
or disable it at any time by again pressing
on the remote control.
Note
There is a separate setting for the backlight when the
timer (snooze) is activated. For example, it can be set to
be dimmer than in normal operation. 15.9. Backlight.
26
settings of your terminal device
®
pairing.
®
on the remote control to set
[MENU]
Main menu
Sleep
[SLEEP]
Hide quick links:
Advertisement
Table of Contents
