Grille Installation; Door Swing - AGA marvel ML15CRS1XS Installation, Operation And Maintenance Instructions

Installation Operation and Maintenance Instructions
11. Remove clamps from door.
NOTICE
If panel requires additional adjustment after removing
clamps, slightly loosen each screw and adjust panel as
necessary. Tighten screws upon completion.
12. Starting at the corners, re-install the gasket into the gasket
channel in the frame. Make sure the gasket is fully seated.
This may take some force.

Grille Installation

REMOVING AND INSTALLING GRILLE
WARNING
!
Disconnect electric power to the unit before
removing the grille.
When using the unit, the grille must be installed.
Removing the grille
1. Disconnect power to the unit.
2. Loosen the two screws (1).
3. Remove grille (2) from unit.
Installing the grille
1. Align cabinet and grille holes and secure, but do not over
tighten grille screws (1).
2. Reconnect power to the unit.

Door Swing

Door Swing
Wall
1/4" Min.
(6 mm)
90°
Door Swing
Units have a zero clearance for the door to open 90°, when
installed adjacent to cabinets.
Stainless Steel and black and white models require
2-1/8" (54 mm) door clearance to accommodate the handle if
installed next to a wall.
Overlay models require 1/4" (6 mm) clearance if installed
next to a wall. Allow for additional space for any knobs or
pulls installed on the overlay panel/frame.
14
Wall
2-1/8" Min.
(54 mm)
90°
Door Swing