Anti-Tip Bracket - AGA marvel ML15CRS1XS Installation, Operation And Maintenance Instructions

Installation Operation and Maintenance Instructions
3. Locate water valve inlet.
4. Break away filler feature in bushing with flat screwdriver.
5. Thread water line through back panel hole (with bushing).
6. Locate water valve inlet and connect to valve.
7. Turn on water supply and check for leaks.
8. Reinstall back panel.
9. Install retaining clip.
Remove
screwdriver

Anti-Tip Bracket

1. Slide unit out so screws on top of unit are easily accessible.
2. Remove the two screws from the opposite side of the hinge
assembly using a T-25 Torx driver (see below).
3. Place bracket over holes and attach to unit with two screws
removed in step 2 using a T-25 Torx driver. Tighten screws
fully.
4. Gently push unit into position. Be careful not to entangle the
electrical cord or water line, if applicable.
5. Check to be sure the unit is level from front to back and side
to side. Make any necessary adjustments. The unit's top
surface should be approximately 1/8" (3 mm) below the
countertop.
6. Secure bracket into adjoining surface.
10