Airflow And Product Loading - AGA marvel ML15CRS1XS Installation, Operation And Maintenance Instructions

Installation Operation and Maintenance Instructions
ICE MAKER ADJUSTMENT
Ice Cube Thickness Adjustment
Interval - As Required
On ice maker equipped models, adjust the cube size by
changing water amount injected into the ice maker assembly as
follows:
1. Remove the ice maker assembly cover (1).
2. Find the adjusting screw on the ice maker assembly control
box (2). The adjusting screw is just below the minus (-) and
plus (+) signs on the control box.
CAUTION
!
Too large of an adjustment to the screw can cause the
water to overflow the ice maker and can cause property
damage.
3. Turn the adjusting screw toward the minus (-) sign
(clockwise) for smaller cubes or toward the plus (+) sign
(counterclockwise) for larger cubes.
1
2
4. Install the ice maker assembly cover.
ADJUSTING ICE HARVEST
1. Remove the front grille (see GRILLE INSTALLATION).
2. Using a flat tip screwdriver, turn the adjusting screw (3) a
small increment clockwise for a COLDER setting (slower ice
production) or counterclockwise for a WARMER setting
(faster ice production).
1
2
3. Reinstall the front grille (two screws).

Airflow and Product Loading

NOTICE
The unit requires proper airflow to perform at its highest
efficiency. Do not block the front grille at any time, or the
unit will not perform as expected. Do not install the unit
behind a door.
19
3
Warmer Colder