Cleaning Condenser - AGA marvel ML15CRS1XS Installation, Operation And Maintenance Instructions

Installation Operation and Maintenance Instructions
DEFROSTING
Manual Defrost Models
Unit is a manual defrost model and will require occasional
defrosting. When there is build-up of 1/4" (6 mm) or more of
frost, manually defrost the unit.
CAUTION
!
DO NOT use an ice pick or other sharp instrument to help
speed up defrosting. These instruments can puncture the
inner lining or damage the cooling unit. DO NOT use any
type of heater to defrost. Using a heater to speed up
defrosting can cause personal injury and damage to the
inner lining.
To defrost:
1. Disconnect power to the unit.
2. Remove ice bucket and discard ice.
3. Place towel or other absorbent material on bottom of ice bin.
4. Fill the ice bucket half full with warm, not hot water. This will
help the unit defrost faster.
5. Place the ice bucket back into the unit on top of a towel or
other absorbent material.
6. Prop the door in an open position (2 in. [50 mm] minimum).
7. After about 1 hour remove the ice bin and discard water.
8.
Allow the frost to melt naturally.
9.
After the frost melts completely clean the interior and all
removed components. (See INTERIOR CLEANING).
NOTICE
DO NOT clean ice bucket using a dishwasher. The bucket is
not dishwasher safe and will be damaged.
10. When the interior is dry, reconnect power and turn unit on.
NOTE: To safeguard against contamiments in ice,
discard first three batches of ice after defrosting.

Cleaning Condenser

INTERVAL - EVERY SIX MONTHS
To maintain operational efficiency, keep the front grille free of
dust and lint, and clean the condenser when necessary.
Depending on environmental conditions, more or less
frequent cleaning may be necessary.
WARNING
!
Disconnect electric power to the unit before
cleaning the condenser.
NOTICE
DO NOT use any type of cleaner on the
condenser unit.
1. Remove the grille. (See GRILLE INSTALLATION).
2. Clean the condenser coil using a using a soft brush
with a "combing" action or vacuum cleaner. Do not
touch the condenser coil.
3. Install the grille.
Condenser
21