Overlay Door Panel Installation - AGA marvel ML15CRS1XS Installation, Operation And Maintenance Instructions

Installation Operation and Maintenance Instructions

Overlay Door Panel Installation

1. Fully open door.
2. Starting at corner, pull gasket
away from door.
3. Continue to pull gasket free
from gasket channel.
4. Upon removal, lay gasket down on a flat surface.
5. The panel should be aligned with the outside edge
(opposite the hinge) and high enough to align with the
highest point in the door.
Align Top Of Panel With Highest Point Of Door
NOTICE
Due to differences in floor construction or surrounding
cabinetry, the panel may not sit flush with the top of
the door.
Panel
- ML15CRP1XP
Align Panel
Against
Door Edge First
Door
6.
Secure overlay panel to
door using clamps. A
robust tape may also be
used. AGA Marvel
recommends the use of
bar clamps to secure the
panel to the door. If using
tape, be certain the tape
will not damage panel
finish upon removal.
7. Using a 7/64" (3 mm) drill
bit, drill 6 pilot holes into
the wood panel 1/2" (12
mm) deep using the holes
in the door frame as a
guide.
It is important to ensure that all drilled holes are drilled to
the correct depth in order to avoid splits in the wood when
hardwood is installed.
8.
Locate 6 of the #6x 1-1/4" (32 mm) screws provided with
your unit.
9.
Using a Phillips screwdriver, place one screw into each of
the 6 pilot holes and screw down. Do not over tighten
screws.
10.
Be sure the screws force their way past the opening on
the gasket channel and sit flush against the bottom of the
channel.
Overlay Panel
13
Bar
Clamp
Door
Wood
Panel
Bar
Clamp
Overlay Panel