General Installation - AGA marvel ML15CRS1XS Installation, Operation And Maintenance Instructions

Installation Operation and Maintenance Instructions

General Installation

LEVELING INFORMATION
1. Use a level to confirm
the unit is level. Level
should be placed
along top edge and
side edge as shown.
1
2. If the unit is not level,
adjust the legs on the corners of the unit as necessary.
3. Confirm the unit is level after each adjustment and repeat
the previous steps until the unit is level.
INSTALLATION TIP
If the room floor is higher than the floor in the cutout opening,
adjust the rear legs to achieve a total unit rear height of 1/8"
(3 mm) less than the opening's rear height. Shorten the unit
height in the front by adjusting the front legs. This allows the
unit to be gently tipped into the opening. Readjust the front legs
to level the unit after it is correctly positioned in the opening.
Turn to Adjust
11
INSTALLATION
1. Plug in the power/electrical cord.
2. Gently push the unit into position. Be careful not to entangle
the cord or water and drain lines.
3. Re-check the leveling, from front to back and side to side.
Make any necessary adjustments. The unit's top surface
should be approximately 1/8" (3 mm) below the countertop.
4. Install the anti-tip bracket.
5. Remove interior packing material and wipe out the inside of
the unit with a clean, water-dampened cloth.